Start Task
If the status of a data synchronization instance that is already configured is Not started, you can click Start Task to start a synchronization task.
On the Instance List page in the Data Sync module, click the ID of a Not started instance and go to the Instance Management page.
On this page, click Start Task at the bottom.
In the pop-up window, click OK to start the instance task.
After you submit the task, the instance status changes to Running on the Instance List page in the Data Sync module.
Resuming a Task
After you configure a DTS task, you may pause the task when the task is running, or the task may encounter an error. At this time, the task stops running and its status changes to Not started.
After you solve the issues, you can click Start Task to resume the task.
On the Instance List page in the Data Sync module, find the instance for which you need to resume a synchronization task. Click the ID of the instance to go to the Instance Management page. Then, click Start Task. This way, DTS resumes synchronization from the offset at which DTS has stopped synchronization.
The other steps are similar to those in the "Start a Task" part of this section.